Sunsystem BURNiT PM Comfort 13 Plus, Service Manual

Page: 31 / 47

Installer / Service Manual BURNiT PM Comfort
Plus
31 –ЕN
1
Reached the Boiler Thermostat the
stove goes in Modulation, then if
d23 is satisfied and T43 is finished it
goes in Standby
A14
0 Error Sensor Pressure disabled
0 1 [nr] 0
1 Error Sensor Pressure enabled
A19
0 Room Thermostat ON/OFF selected
0 1 [nr] 1
1 Room Probe selected
А26
0
The immediate Exit from StandBy is
allowed
0 1 [nr] 0
1
Exit from Standby is allowed
>after the timer T13 and
> if the Exhausting
Temperature<Th28
A28
0 Auger brake not activated
0 1 [nr] 0
1 Auger brake activated
A50
0 Modem Management disabled
0 1 [nr] 0
1 Modem Management enabled
P02
Maximum number ignition attempts 1 5 [nr] 1
P03
Work Combustion Powers’ number 1 5 [nr] 5
P09
Pellet Sensor configuration:
0 1 [nr]
0
P20
Configuration of Pressure Boiler Water
Sensor
0 2 [nr]
0
P26
Plumbing system management
0 1 [nr]
0
6.7.6. Outputs Menu Test TP 12
It allows the test of the single management outputs with the connected devices. The
function is available in
OFF state.
Code Description Min. Max. U Def.
To01 Auger Test OFF ON -
To03 Combustion Fan Test 0 230 [Volt]
300 2800 [RPM]
During Combustion Fan Test, upper display shows the set value [Volt] [RPM],
bottom display shows the RPM of the fan detected by the encoder if is present: so it is possible
to create a conversion table [RPM] / [Volt] to use for the passage from encoder Mode
P25=1
to not encoder Mode P25=0 in case of encoder breakage.
To04 Igniter Resistance Test OFF ON -
To05 Pump Test OFF ON -