SunSynk SUNSYNK MAX, User Manual

Page: 45 / 71

MAX | User Manual 45
What you can do from this page:
ƒ
Set up you Lithium-ion battery.
After installing a lithium battery, check on the communications page by clicking on the ‘Li BMS’ icon to see if
the BMS information is visible. If some information is not displayed correctly (it should look like the diagram
below) then there will be a communication error.
Therefore, if a communication error occurs:
1. Check that your data cable is the correct type.
2. Check that the data cable is plugged into the correct sockets. Usually, RS485 is employed, but some bat
-
tery manufacturers use others.
PLEASE NOTE
With some types of lithium battery, the BMS cannot be controlled by the Sunsynk inverter. In this case,
treat the battery as a lead-acid type and set the charging and
discharging protocol following the bat-
tery manufacturer specification.
It is important to refer to the manuals that manufacturers produce for their batteries. That way, the chance
of errors occurring during installation are greatly reduced. Below there is a list of batteries that has been
examined, tested, and approved by Sunsynk.
Brand Model
48V
Storage
Inverter
RS485
or CAN
Inverter
Setup
Notes
DYNESS
B4850

CAN
0
POWERBOXF 0
SolarMD
SS4074

CAN
0 To be used with V2 Logger
http://solarmd.co.za/
inverter-compatibility-so-
larmd/ sunsynk-and-solar-
md/
SS4037 0
SS202 0
SHOTO SDC10-Box 5

CAN 0