SunStar KM-570BL, User Manual

Page: 14 / 29

14
3) Winding the lower thread
Insert the bobbin ② into the hook ① . As seen in Figure 12,
insert the thread through part of the hook and pull it out
from the end of the lower thread tension adjustment plate
③
. And then pull the thread through the clearance
⑤
between the hook
①
and opener
④
. The adequate length of
the pulled-out lower thread on the slide plate is 50 mm.
[Figure 12]
Lower
thread
About 50 mm
④
⑤
③
②
①
4) Routing the upper thread
Place the thread take-up lever to the highest position and
hang the upper thread as in Figure 13.
※
The adequate length of upper thread extending from the
needle hole is 50 mm for initial sewing.
[Figure 13]
Caution
▶ In case of adjusting the tension of the lower thread, be sure to switch off the power supply.
If the users press on the step by mistake, the machine runs automatically. By doing so, it can
cause the physical injuries.
▶ In case of using the clutch motor, the motor revolves because of inertia for a while even after
switching off the power supply.
Caution
▶ In case of taking up the upper thread, be sure to switch off the power supply.
If the users press on the step by mistake, the machine runs automatically. By doing so, it can
cause the physical injuries.
▶
In case of using the clutch motor, the motor revolves because of inertia for a while.
Be sure to start to work only after the motor comes to a complete stop.
50mm