11--22
1) Encoder 1 Set, Encoder 2 Set
Normal embroidery encoder could be set by pressing “ENCODER1 SET”. While spinning the encoder by hand, at
some point, you can hear a “beep” sound and see “ON” displayed on the screen. At this time, set the main shaft
angle at 100 and fix the encoder.
Chenille embroidery encoder could be set by pressing “ENCODER2 SET”. Just like normal embroidery encoder
setting, while rotating the encoder by hand, you can hear a “beep” sound at some point and see “ON” displayed on
the screen. At this time, set the main shaft angle at 35 and fix the encoder.
To be noted, when setting encoders, for normal embroidery, the main shaft angle should be set at 100 , but for
Chenille embroidery, the machine shaft angle should be set at 35 .
If the "Setting" button is pressed on the machine setting screen as in “3.2.0 Machine Setting Change” of SA manual,
the screen as in <Fig. 1.2-1> appears.
1.2
Machine Setting
[WARNING]
Wrong setting could cause errors to the machine. Do not change the default setting, unless you have accurate
setting information.
[Fig.1.2-1]