930583 Rev. D
O. SEAT DEPTH AND ANGLE ADJUSTMENT ON SEAT FRAME
(Figure 25)
A backrest angle adjustment is standard on the Contour seat, the Highback Contour seat
and the Seat Frame.
a. Remove the front securing bolt (A) on the side of the backrest hinge plate.
b. Loosen the lower rear bolt (B).
c. Set at desired angle. Adjustment is from 86° to 115°.
d. Reinstall the front bolt (A) and tighten both bolts securely.
P. FOLDING BACKREST (Seat Frame)
(Figure 26)
Folding backrests are shipped with backrest in folded position.
1. Upright Positioning
a. Lift backrest to upright position so that latch handles (C) lock into place.
b. Backrest is ready for use.
2. Folding Backrest
a. Lift and turn backrest latch handles (C) inward or outward.
b. Fold backrest forward.
Q. SHROUD REMOVAL
The plastic protective shroud can be removed for adjustment or servicing.
1. Remove Colored Shroud
Two removable colored shroud covers are Velcro
®
-ed on to the sides of the main shroud. To
remove, simply peel the colored shroud off of the main shroud as shown in Figure 27.
2. Remove Main Shroud
a. Remove both brake releases by unscrewing the front connection and pulling them
out. (Figure 28)
b. Lift the middle shroud assembly off.
3. Replace Main Shroud
Replace shroud by reversing above instructions.
R. PARAPAK SEAT SLING ADJUSTMENT (Seat Frame)
(Figure 29)
The seat sling tension can be adjusted through use of the Velcro® retaining material
beneath the seat.
a. Remove the screws retaining the left side seat sling.
b. Readjust Velcro®-style material to increase the tension in the seat sling.
c. Replace screws and tighten.
Important Note–
If there is any difficulty in re-attaching the screws, try using a probe to help line up
the holes.
I X . S e t - U p , A d j u s t m e n t & U s e
25
E n g l i s h
26
C
25
27
28
A
B
29
