C. HANGER ADAPTER (OPTIONAL)
(Figure 7)
1. Insert hanger adapter into seat frame interface.
2. Tighten thumb screw knob.
D. SWING-AWAY FOOTRESTS
1. Installation
(Figure 8)
a. Place swing-away pivot pin (A) into the locating hole (B) on top of the hanger
mount with the footrest facing outward from frame.
b. Rotate the footrest inward until latch plate locks into place on locking bolt.
2. Removal
(Figure 9)
a. To remove footrest, press quick-release lever (C).
b. Rotate footrest outward and lift.
3. Height Adjustment
(Figure 9)
a. Loosen the bolts (D) in the hanger frame tube and the clamp.
b. Reposition footrest height.
c. Re-tighten bolts.
Avoid opening doors with footplate or legrests. Damage or injury may result.
E. ELEVATING LEGREST (OPTIONAL)
(Figure 10)
1. Installation
To install or remove Elevating Legrest (ELR) see instructions for Swing-away Footrest instal-
lation above.
2. Adjustment
a. To raise legrest, lift to desired position. Legrest will automatically lock in place.
b. To lower legrest, while seated in chair, first lift slightly, then press release lever (E)
up and lower legrest to desired position.
F. INTEGRAL JOYSTICK
(Figure 11)
1. To Connect
a. Line up receptacle on large rectangular connector (Beau Connector) and AMP connec-
tor located behind the seat with the pins on the connecter located on the joystick
harness.
b. Push in firmly.
2. To Disconnect
Pull up on beau connector until it disconnects from the frame mounted receptacle, located
behind the seat. Pinch the sides of the AMP connector and then pull.
G. REMOTE JOYSTICK INSTALLATION
(Figure 12)
1. To Connect
a. Line up female cylindrical connector (F) with its male receptacle on the end of the
power cable (G).
b. Push in firmly.
2. To Disconnect
Pull back on the retaining ring of the cylindrical connector (F) until it disconnects from the
power cable (G).
930583 Rev. D
22
E n g l i s h
I X . S e t - U p , A d j u s t m e n t & U s e
7
11
12
A
B
C
D
8
9
10
E
F
G
