nstallation
I
1
Tools Required
You’ll need the following tools to assemble your booth:
Knife (Utility or similar)
#2 Phillips Screw Driver
Adjustable Wrench
Pre-Installation Planning
Before you begin to assemble your booth, you should observe the following pre-
installation considerations.
• Your booth operates from a 220V AC source. The unit must be hard-
wired to a dedicated circuit capable of providing
60 amp
service.
Electrical connection of this unit requires a professional electrician.
•
IMPORTANT!
Voltage must be below 230 VAC or may require a Buck
Booster, contact ETS service at the number at the back of this guide. Use
of a voltage source above 230 VAC may reduce the life of some compo-
nents in your booth.
• Make sure the room in which you intend to use your booth is well ven-
tilated. Air from the room is used to cool the booth, and a poorly venti-
lated room may cause the unit to become hot and cause discomfort to
the user.
• Your sunbed is designed to operate in an ambient room temperature of
80°F maximum and 70% relative humidity.
