Using Your Booth
When configured as a stand alone unit or when connected to a remote system using a
control relay
.
If your booth is connected to a ComputaTAN™ or T-Max
®
Manager remote system, turn
to
Using Your Booth When connected to the ComputaTAN
™
or T-Max
®
Manager
.
Step 1.
Enter the booth and shut the door behind you. Center your body on the pedestal
so that it will allow for even tanning.
Step 2.
Start the booth by pressing the timer button (E) located on the control console
located at the top of the booth. The lamps will turn on and the timer display (C) will indi-
cate the session time remaining.
Note:
If the lamps do not come on then either the remote bypass plug is not installed see,
Making Electrical Connections
or an external timer is being used that has not yet been acti-
vated. The timer will not begin to count down until the remote system activates.
Step 3.
If less than the maximum tanning time is desired, repeatedly press the timer button
(E) until the desired time is indicated.
Step 4.
Turn on the body fans located in the pedestal by pressing button (A). View indicator
(B) to determine the if body fans are on. When the bar (B) is fully lit the fans are on and
when nothing is lit they are off.
Step 5.
When the timer reaches 0, the lamps will turn off. If you want to stop your session
before the time expires press the stop button (D). The booth will then allow you ten sec-
onds to reactivate the unit with the unused time. After ten seconds the timer system resets
back to 0 minutes.
Step 6.
Exit the booth when the lamps shut off. The cooling fans run for 3 minutes after the
lamps shut off to aid in cooling the booth.
A
B C D E
8
Operation-Using Your Booth
