Using Your Booth
When connected to the ComputaTAN™ or T-Max
®
Manager
Step 1.
Enter the booth and shut the door behind you. Center your body on the pedestal so
that it will allow for even tanning.
Step 2.
Observe the timer display. Assuming the remote system has been set to allow a pre-
tanning delay time, the display will repeatedly flash the delay symbol “dL” and then the
remaining delay time. Either press the timer button (E) or wait until the delay time has expired
to begin the tanning session. The display will now indicate the tanning time set by the
remote system, the lamps will turn on and the timer will begin to count down. The booth will
not allow a session time greater than the booth’s maximum exposure time.
If the timer did not display a “dL” but does indicate a;
“0” then the remote device has not yet been set.
tanning time and the lamps have come on, then either a delay time was not set or
the delay time has already expired and the tanning session has begun.
tanning time and the lamps have not come on, then the auto start function of the
external remote system has been turned off. Press the timer button(E) to turn on the
lamps.
Step 3.
If a tanning time less than the displayed time is desired repeatedly press the timer
button(E) to decrease the remaining time.
Step 4.
To turn on or off the the fans, located in the pedestal press button (A). When the bar
(B) is fully lit the fans are on and when nothing is lit they are off.
Step 5
. When the timer goes below 1 minute it will begin to count in seconds until it reaches
0, then the lamps turn off. If you want to stop your session before time expires press the stop
button (D).
Operation-Using Your Booth
9
A
B C D E
