Cleaning After Use
Clean and disinfect your tanning booth’s pedestal, handles, control console and wire grid
after each use. Use a non-abrasive disinfectant cleaner. We recommend
SunQuest
disin-
fectant. Spray a clean soft cloth with disinfectant and then clean all surfaces that the tan-
ner may have come in contact with.
Thorough Periodic Cleaning
Introduction
The cooling fans draw air through the booth and over time will cause a dust buildup on
the lamps and reflectors. This will reduce the tanning effectiveness of the booth. When a
dust buildup is observed, it is necessary to thoroughly clean the inside of the booth.
Warning!
Disconnect booth from electrical power before cleaning.
Cleaning the Booth
Step 1.
Remove the wire grids and lamps as described in
Replacing Lamps.
Step 2.
With a soft cloth, wipe the entire length of each lamp and reflector
to remove any film build-up.
Step 3.
Re-install the lamps and wire grids as described in
Replacing Lamps.
Mechanical Inspection
Your tanning booth has been built for years of service. To ensure trouble free operation
throughout its life, inspect the unit’s mechanical integrity every 400-500 hours of use.
• Inspect the unit’s fasteners verifying that all are firmly in place. Pay particular attention
to the door alignment. Adjust the door casters as needed. See
Assembly Step 2.
• Inspect the AC power cable and its connections.
10
are & Maintenance
C
