Sun Microsystems Ultra Enterprise 3000, Installation Manual

Page: 24 / 48

2-2 Ultra Enterprise 3000 System Installation Guide—May 1996
2
Figure 2-1 Key Switch Standby Position
3. Turn the AC power switch to Off.
This switch is at the rear of the system, on the peripheral power supply/AC
(PPS/AC) that is installed in the far left corner. See Figure 2-2.
4. Connect the female end of the power cord into the AC connector.
This connector is at the rear of the system, on the PPS/AC, just below the
AC power switch. See Figure 2-2.
5. Route the power cord through the power cord retainer clip.
A plastic clip is attached to the back support bracket. See Figure 2-2.
a. Use a Phillips screwdriver to open the plastic retainer clip.
Remove the screw.
b. Place the power cord inside the open clip.
c. Replace the screw to reattach the retainer clip to the support bracket.
Standby