Chapter 4
Installing and Removing Devices
4-3
4. Remove the filler panel that covers where you will install the device (
FIGURE 4-1
).
a. Use a #2 Phillips screwdriver and loosen the captive screws that fasten the
panel to the cabinet.
b. Remove the filler panel and save it for future use.
Note –
To maintain proper airflow, filler panels must be installed over locations that
do not have devices mounted.
FIGURE 4-1
Filler Panel and Trim Strip Installation
5. If the expansion cabinet is not bolted to the ground, extend the stabilizer legs.
The stabilizer legs are located under the front of the cabinet.
Caution –
Only extend or retract the stabilizer legs as a pair. Be sure that the
levelers have been adjusted before attempting to move the stabilizer legs.
Trim strip
Filler panel
Installed device
