LabVIEW
™
, Measure
™
, National Instruments
™
, ni.com
™
, PXI
™
, and SCXI
™
are trademarks of National Instruments Corporation. Product and company
names mentioned herein are trademarks or trade names of their respective companies.
320722B-01
©
Copyright 1994, 2000 National Instruments Corp. All rights reserved.
November 2000
INSTALLATION GUIDE
SCXI -1346 S
HIELDED
M
ULTI
-C
HASSIS
C
ABLE
A
DAPTER
This guide describes how to connect and configure a multi-chassis
SCXI system using the SCXI-1346 shielded multi-chassis cable adapter.
Introduction
Using the SCXI-1346, you can connect a multi-chassis SCXI system to
your data acquisition (DAQ) device. The SCXI-1346 connects any 68-pin
E Series DAQ device, excluding 61
XX
E devices, to any SCXI module,
excluding the SCXI-1127, SCXI-1128, SCXI-1190, and SCXI-1191.
The SCXI-1346 is a connector assembly with four connectors:
•
A 68-pin male connector on the front panel of the adapter, labeled
TO NEXT CHASSIS
•
A 68-pin male connector on the front panel of the adapter, labeled
FROM DAQ BOARD OR PREVIOUS CHASSIS
•
A 50-pin, male breakout connector on the printed-circuit board of the
adapter
•
A 50-pin, bracket-mounted female connector on the rear of the adapter
™
Summary of Contents for SCXI 1346
Page 19: ......
