©
National Instruments Corporation
7
SCXI-1346 Shielded Multichassis Cable Adapter
4.
Install the SCXI-1349 chassis adapter into the last SCXI chassis in
the chain. Mate the 50-pin female connection on the rear of the
SCXI-1349 with the 50-pin male connector on the rear of the
appropriate SCXI module. (The appropriate module was determined
in step 3 of the
Installing Modules in Your SCXI Chassis
section
earlier in this document.)
5.
Using the two screws provided with the SCXI-1349 chassis adapter,
fasten the adapter to the rear of the SCXI chassis.
6.
Connect either end of one 68-pin shielded cable to the DAQ device.
Connect the other end of the 68-pin shielded cable to the SCXI-1346
in chassis ID
n
labeled
FROM DAQ BOARD OR PREVIOUS
CHASSIS
.
7.
Connect a 68-pin shielded cable to the SCXI-1346 in chassis
n
labeled
TO NEXT CHASSIS
.
8.
Connect the other end of the cable to the SCXI-1346 in chassis ID
n+
1
labeled
FROM DAQ BOARD OR PREVIOUS CHASSIS
.
9.
Repeat steps 7 and 8 for the remaining chassis until you reach the last
chassis.
10. Connect the 68-pin shielded cable to the next to the last chassis in the
slot labeled
TO NEXT CHASSIS
.
11. Connect the other end of the cable to the SCXI-1349 in the last chassis.
Summary of Contents for SCXI 1346
Page 19: ......