Sun Microsystems SPARCcenter 2000E, Installation Manual

Page: 31 / 54

Power Supply Installation 2-15
2
2.5.2.5 Cabling
Filter Cable, Breaker Box and AC Distribution Unit
1. Plug in the filter cable.
Form a service loop in the cable and plug the connector into J2 (the top
connector) on the power supply. See Figure 2-15.
2. Replace the power breaker box. See Figure 2-15.
c. Insert the filter cable service loop into the hole in the back side of the
breaker box (Figure 2-15).
Note – Insert filter cable loop into the hole in breaker box that is surrounded
by springfingers.
Figure 2-15 Plugging the Filter Cable into the Bottom Power Supply
Service loop
Rectangular hole
Breaker box
(cutaway view)