20
Sun RSM Array 2000 Controller Module Installation Guide • October 1997
FIGURE 1-16
Tightening the Mounting Clamp
4. Replace all of the canisters that you removed earlier.
Re-install the controllers, controller fan, battery, power supplies, and power supply
fan into the chassis by reversing Step 3 on page 12. Make sure that you:
a. Install the controllers in their correct slots (1[B] or 2[A]).
b. Lock all canisters securely into place.
c. Leave the front panel off. You will need to be able to view the controller LEDs
later in this installation process.
Note –
The power supplies are interchangeable, so you can insert them in either
slot.
▼
To Connect the Cables
■
Tools: None
■
Equipment: SCSI bus cables, SCSI drive cables, terminators, and tie wraps
1. Install 16-bit, differential terminators to both host SCSI OUT connectors on the
back of the controller module (
FIGURE 1-18
).
Mounting clamp
Screws (2 on
each side)