18
Sun RSM Array 2000 Controller Module Installation Guide • October 1997
Installing the Controller Module
This procedure explains how to install the controller module chassis into the cabinet
and connect the cables.
When you set the chassis in the cabinet, make sure that:
■
The slots on the back of the controller module slide beneath the mounting clamps
(in the rail supports).
■
You insert all of the canisters properly and lock them in place.
■
The air vents above the power supplies and fans are free of obstructions. This
includes interface cabling that exits the back of the controller module. Once you
connect the cables to the controller module, secure them to the inside of the
cabinet framework with tie wraps. Be careful not to route the cables across any
sharp edges.
▼
To Install the Controller Module
■
Tools: #2 Phillips screwdriver
■
Equipment: None
1. Facing the front of the cabinet, set the controller chassis on the support rail and
slide it into the cabinet (
FIGURE 1-15
).
Make sure the slots on the back of the chassis slide beneath the mounting clamps.
2. Install two #10 screws in each side of the support rail and chassis
(
FIGURE 1-15
).
There are two holes on each side of the controller module chassis that align with
holes in the support rails.