8
Sun RSM Array 2000 Controller Module Installation Guide • October 1997
FIGURE 1-6
Routing the Power Cords
▼
To Install the Support Rails
■
Tools: #2 Phillips screwdriver
■
Equipment:
■
Support rails (2 each)
■
#10 Phillips-head screws
■
#8 Phillips-head screws
1. Unpack the rackmounting hardware.
You should have 2 support rails and at least 12 screws in two sizes (#8 and #10).
Power sequencers are
located on either the
left or right side,
depending on the type
of cabinet you have.
Power cords connect to
power sequencers, then
route through the bottom
cable access hole.