Chapter 1
Installation
3
FIGURE 1-1
Installation Worksheet
❍
Prepare Cabinet
❑
Remove front, back, and side panels
❑
Turn off main circuit breakers
❑
Set SCSI IDs on drive trays
❑
Connect controller module power cords to
cabinet
❍
Prepare Rails
❑
Unpack rackmounting hardware
❑
Install the rail supports
❍
Prepare Controller Module
❑
Remove canisters from controller module
❑
Set host SCSI IDs on controller module
❑
Fill out the Battery Support Information
label
❍
Install Controller Module
❑
Slide controller module onto rail support
❑
Install the mounting screws
❑
Tighten the mounting clamp
❑
Replace canisters
❑
Install SCSI terminators
❑
Connect drive tray SCSI cables to controller
module
❑
Connect host SCSI cables to controller module
❑
Connect power cords to controller module
❍
Complete Installation
❑
Turn on both main circuit breakers
❑
Check for Fault LEDs
❑
Replace panels on cabinet
❑
Install necessary software and configure system
❑
Test SCSI bus and devices
System Information
Cabinet ID (name or number)
No. of devices installed (tape/drive trays, etc.)
Drive Tray SCSI ID Settings
NOTES
Controller Module Information
Model #
Serial #
Date Installed
Installer’s Name
Installation Location
Controller SCSI ID Settings#1____ #2____
Date on Battery Module
CONTROLLER MODULE SETUP
INSTALLATION TASKS
Installation Worksheet