24
Sun Blade X6270 M2 Server Module Installation Guide • October 2010
8. To set a static IPv6 address, complete these steps:
a. Specify the following property values:
b. Commit the pending IPv6 static network parameters by typing the following
command:
->
set commitpending=true
Note –
Network settings are considered pending until you commit them. Assigning
a new static IP address to the device (SP or CMM) will end all active ILOM sessions
to the device. To log back in to ILOM, you will need to create a new session using
the newly assigned IP address.
9. Test the IPv4 or IPv6 network configuration from ILOM using the Network Test
Tools (Ping and Ping6).
For details, see
“Test IPv4 or IPv6 Network Configuration” on page 25
.
Property
Set Property Value
Description
state
set state
=
enabled
The IPv6 network state is
enabled
by default.
To enable a static IP address this state must be
set to
enabled
.
pendingipaddress
set
pending_static_ipaddress
=
<
ip6_address
>/
<subnet mask length
in bits
>
Type this command followed by the property
value for the static IPv6 address and net mask
that you want to assign to the device.
IPv6 address example:
fec0:a:8:b7:214:4fff:feca:5f7e/64
