Chapter 3
Connecting to ILOM and Applying Main Power to the Server Module
23
7. To configure an IPv6 auto-configuration option, use the
set
command to
specify the following auto-configuration property values:
Note –
The IPv6 configuration options take affect after they are set. You do not need
to commit these changes under the
/network
target.
Note –
You can enable the
stateless
auto-configuration option to run at the same
time as when the option for
dhcpv6_stateless
is enabled or as when the option
for
dhcpv6_stateful
is enabled. However, the auto-configuration options for
dhcpv6_stateless
and
dhcpv6_stateful
should not be enabled to run at the
same time.
Property
Set Property Value
Description
state
set state=enabled
The IPv6 network
state
is
enabled
by default. To enable
an IPv6 auto-configuration option this
state
must be set to
enabled
.
autoconfig
set autoconfig=
<
value
>
Specify this command followed by the
autoconf
value you
want to set.
Options include:
•
stateless
(default setting)
Automatically assigns IP address learned from IPv6
network router.
•
dhcpv6_stateless
Automatically assigns DNS information learned from the
DHCP server.
The
dhcpv6_stateless
property value is available in
ILOM as of 3.0.14.
•
dhcpv6_stateful
Automatically assigns the IPv6 address learned from the
DHCPv6 server.
The
dhcpv6_stateful
property value is available in
ILOM as of 3.0.14.
•
disable
Disables all auto-configuration property values and sets
the read-only property value for link local address.
