1.
Slide the swaged end of the Seat Frame - Left (
item A
) into the Jog Tube - Left (
item C
) and secure together using (1) 40mm
bolt and locknut.
See figure 1 and 2
.
Note: Jog Tube must be oriented as shown in figure 2.
2.
Repeat process for Seat Frame - Right (
item B
) and Jog Tube - Right (
item D
).
3.
Lay the Foot Platform (
item E
) and Rear Platform (
item F
) on a table so that the ends mate as shown in
figure 3
.
Note: The welded plate on the Platform Rear and expanded metal on the Foot Platform should be facing up.
Note: DO NOT install a bolt in the center hole of the Foot Platform at this point. This will be done on a later step.
Secure together using (4) 65mm bolts and lock nuts.
4.
Insert the Seat Frame subassemblies into the Foot Platform as shown in
figure 4
. Insert (1) 50mm bolt and locknut to hold
this location. Thread the locknut just tight enough to retain the tube on the bolt.
Note: This bolt will be removed in a later step.
Note: the welded tabs on the Seat Frame subassemblies should be facing toward the center of the Foot Platform.
PG 5
Tools
• 13mm Wrenches and / or Socket / Ratchet
- Assembly can be made easier by the use of a powered ratchet or drill with socket adapter (take care not to overtighten
when using power tools to assemble)
- It is recommended that all bolts be sorted by thread count / length prior to assembly.
** Assemble entire product before fully tightening any bolts / lock nuts.
DO NOT OVER-TIGHTEN the bolts and nuts to the point that the tubing becomes deformed or bent.
TOOLS REQUIRED
4
ASSEMBLY
5
PLATFORM / SEAT ASSEMBLY
1
SWAGED END
A
C
2
A
C
E
F
BOLT LOCATION
BOLT LOCATION
3
4
BOLT LOCATION
WELDED TABS
FACING TOWARD
PLATFORM
