OPERATION & MAINTENANCE
7
VRT Renegade is
not running
straight or is “dog
tracking”
A.
Blade angle
To move the machine to the
right, increase front angle or
decrease rear. To move
machine to the left, decrease
front angle or increase rear.
B.
Hitch Pitch
Float the hitch or pitch forward
to move right or pitch back to
move left.
8 Wings are going in
too deep.
A.
Wing pressure to high
Reduce wing pressure
B.
Gauge wheels not
contacting the ground
Increase ground wheel
pressure
Increase basket pressure
9
VRT Renegade is
not running level
front to back
A.
Hitch not in correct position
Adjust hitch angle
Run hitch in float
10
Depth of the
machine is not
consistent to the I-
pad settings of the
machine
A.
Communication error
Shut down tractor to break
connection and restart
B.
Sensor
Check for sensor damage
C.
Calibration needed
Calibrate the machine found
under “settings”
11
Blades will not
position to desired
angle
A.
Blade type setting is
incorrect
Go to
“settings” and change the
front and/or rear blade type
setting to desired type.
Concave setting is from 6-19
degrees and coulter is 0-6
degrees.
12 Blade angle will
not change
A.
Auxiliary circuit not engaged Engage Auxiliary circuit
B.
Sensor
Check position sensor for
damage
13
Transport mode
will not run
complete and is
stuck on “activate
cylinder extend on
main lift to raise
machine”
A.
App not responding
Close the app and restart it
–
go through re-phase and
recalibration mode
Disconnect the power (tractor)
and restart
14
Components on
main screen
flashing OR the
incorrect
component moves.
A.
Mapping error
Mapping the IO400’s (check
serial numbers)
Should read as such…
Upper right is #1
Upper left is #2
Lower left is #3
Lower right is #4
2-15
