OPERATION & MAINTENANCE
TRANSPORTING
Before transporting, close ball valve on
center of main frame, and install all
transport locks.
Use a safety chain between tractor drawbar
and VRT Renegade hitch when transporting
on public roads.
Check wheel bolts/nuts after first 20 miles of
road transport and every 60 miles
thereafter.
Road the implement at a reasonable speed,
not to exceed 20 MPH.
Always use an ASABE “Slow Moving
Vehic
le” emblem and safety lights when
transporting on a road or highway. Comply
with your state and local laws governing
lighting and maximum width regulations.
Transport during daylight hours only.
UNHOOKING FROM VRT RENEGADE
Choose a very firm level surface to park.
Either lower wings and blades to the ground
OR install Wing and Lift Cylinder transport
locks.
Check that hitch pin is not bound with
sideways or front to back pressure. If hitch
pin is not free, carefully reposition tractor.
Block tires to prevent movement after hitch
pin is removed.
Lower front AND rear jacks.
Disconnect wire harnesses, hydraulic
hoses, and safety chain.
Recheck that hitch pin is free, if so, stand to
the side of the hitch and remove hitch pin.
Carefully drive ahead.
STORAGE
Clean dirt and debris from all electronics
and sensors.
Inspect machine for damaged or worn parts,
cracked or broken blades, and loose bolts.
Wheel bearings should be inspected
seasonally.
It is recommended to store machine
unfolded, with both the blades and tires on
the ground. If this is not feasible, ensure:
-
Machine is in “Transport Mode”
-Lift Cylinder Locks are in place
-Wing Lock pins are in place
-Hitch Cylinder Stops are in place
-Hitch Ball Valve is closed
-Rolling Basket Shipping Locks are installed
-Front AND rear jacks are lowered
-Wheels are chocked
2-12
