S CLASS™ 2 cutter
User’s Manual
Setup
1-12
1.4
Powering-on the cutter
WARNING:
Make sure the power switch is turned off before connecting the
power cord (the “0” side of the ON/OFF rocker switch should be pressed).
WARNING:
Do not use the power cord if it is visibly damaged. Disconnect the
power cord by pulling the
plug
, not the
cable
.
WARNING: Keep fingers and other body parts away
from the cutting area.
There are
hazardous moving parts
.
1.
Plug the female end of the AC power cord into the receptacle, located in the power
entry module at the cutter’s rear panel.
2.
Plug the male end of the AC power cord into a properly grounded wall socket.
3.
Power on the cutter by pressing the “I” side of the ON/OFF rocker switch, which is
located on the power entry module at the rear panel.
4.
The touch screen will activate and the initialization process will begin. If media is
loaded, the cutter will check the size and load the media.
FIG 1-13
1-13
CUTTER IS LOADED AND READY
FIG 1-14
1-14
CUTTER IS READY - NO MEDIA LOADED
Knife pressure
95 gr
Velocity
800 mm/s
Tool
Tangential knife
Media size
50000 x 718 mm
Actions
Settings
Configuration 1
Pause
Origin
Summa USB port 1
Action
s
Settings
Configuration 1
I
n
s
e
r
t
m
e
d
i
a
a
n
d
l
o
w
e
r
t
h
e
p
i
n
c
h
r
o
l
l
e
r
s
.
Summary of Contents for S Class 2 OPOS-CAM
Page 1: ...User s Manual Rev 3b...
