Sullivan-Palatek 125UD, Operating And Parts Manual

Page: 21 / 64

__________________________________SULLIVAN-PALATEK
21
SECTION 6 MAINTENANCE
6.1 MAINTENANCE SCHEDULE
DAILY

Check lubricoolant level prior to start-up

Check micro processor for any fault or alarm codes (see 5.2 instructions).

Keeping a daily log of all operating parameters is recommended.
FIRST 50 HOURS

Change compressor lubricoolant filter elements.
EVERY 1,000 HOURS

Change compressor lubricoolant filter elements.

If operated in an extreme environment, take sample of lubricoolant and submit for analysis. (Ex:
Chemical Fumes, Oxidizing elements, Fine Dust.)
PALASYN 45 LUBRICANT:
Every 4,000 hours or once a year, whichever occurs first -
Drain Palasyn 45 lubricoolant and replace with a fresh charge. Inspect interior of tank - clean if any build-
up of deposits present. (This may have to be done sooner, depending upon results of lubricoolant
analysis.)
Replace air and oil filter elements and air/oil separator element (sooner if excessive lubricoolant loss is
experienced).
FOOD GRADE – LONG LIFE:
Every 4,000 hours – (If using Food Grade – Long Life)
Change Food Grade – Long Life lubricoolant and inspect tank interior. Replace lubricant filters and air/oil
separator element.
PALLUBE 32P LUBRICANT:
Every 8,000 hours - (If using Pallube 32p)
Change Pallube 32p lubricoolant and inspect tank interior.
Replace lubricant filters and air/oil separator element.
PAL-EXTRA 44 LUBRICANT:
Every 10,000 hours - (If using Pal-Extra 44)
Change Pal-Extra 44 lubricoolant and inspect tank interior.
Replace lubricant filters and air/oil separator element.
AS REQUIRED:
1. Clean or replace air filter element.
2. Clean exterior surfaces of oil cooler/aftercooler.
3. Lubricate motor (refer to motor manufacturer’s instructions.)
4. Clean & grease MPV with Lithium Grease ex: Lubriplate 630-2 or Mobil SHCPM.
5. Rebuild inlet valve every two years.
6. Check electrical connections for tightness. Ensure disconnect switch is locked open.