Sullivan-Palatek 125UD, Operating And Parts Manual

Page: 20 / 64

SULLIVAN-PALATEK__________________________________
20
5.4 NORMAL OPERATION
1. Open and lock out main power disconnect.
2. Check lubricoolant level. Refill if necessary.
3. Re-close disconnect switch. Micro processor will illuminate indicating compressor is ready to start.
4. Fully open service air valve.
5. Start machine by pressing ‘run’ button on micro processor.
Observe pressure and temperature. If temperature is incorrect, refer to SECTION 6.7 – TROUBLE
SHOOTING. Observe pressure and temperature. If temperature is incorrect, refer to SECTION 6.7
– TROUBLE SHOOTING
.
5.5 SHUTDOWN
To stop compressor, press ‘stop’ key on micro processor.
5.6 RESTARTS
After a power failure, open and lock out the main disconnect, check all fuses and breakers. Close
disconnect switch and follow Normal Operation start-up procedure.
Following a shutdown caused by either of the protective devices (i.e. temperature or R.O.P.), open and
lock out the main disconnect switch, correct the cause of shutdown, reset electrical controls, then close
the disconnect and follow Normal Operation start-up procedure.
Check lubricoolant level. Refill if necessary.
Re-close disconnect switch.
Start machine by pressing ‘run’ key on micro processor.
Fully open service air valve.
Observe pressure and temperature displayed by micro processor.