Sullair LS20TS, Operator'S Manual And Parts List

Page: 29 / 98

Section 3
SPECIFICATIONS
23
3.1 SPECIFICATIONS- LS20TS
DIMENSIONS WITHOUT ENCLOSURE (I)
Model Series Length Width Height Weight
in mm in mm in mm lb kg
LS20TS 800 CFM 157.00 3988 71.69 1821 92.09 2339 (II) (II)
LS20TS 960 CFM 157.00 3988 71.69 1821 92.09 2339 (II) (II)
(I) For information concerning enclosed compressors, please contact the Sullair Factory Sales Department.
(II) For information concerning compressor weight, please contact the Sullair Factory Sales Department.
For noise level information, please contact the Sullair Factory Service Department.
3.2 LUBRICATION GUIDE-STANDARD COMPRES-
SORS
Refer to Figure 3-1 for fluid fill port location. Sullair
standard compressors are filled with Sullube fluid
as factory fill.
To be sure that you receive the correct fluid for
your compressor, when ordering fluid, always
confirm your compressor’s fluid fill with the parts
technician by using your compressor’s serial
number.
Mixing of other fluids within the compressor will
void all warranties.
Sullube fluid should be changed every 1800 hours
or once a year, whichever comes first. The fluid
should be changed more frequently under severe
operating conditions, such as high ambient temper-
atures coupled with high humidity, or when high
particulate level, corrosive gases or strong oxidizing
gases are present in the air.
COMPRESSOR:
Type: 2-Stage Oil Flooded Rotary
Maximum Full Load Operating Pressure: 350 psig (24.1 bar)
Bearing Type: Anti-Friction
Cooling: Pressurized Compressor Fluid
Lubricant: Sullube
System Fluid Capacity (refill): 50 U.S. Gallons (189.3 Liters)
Control: Supervisor II Controller
MOTOR:
Type: O.D.P., 460V, A.C., Three Phase, 60 Cycles
Size: 300, 350, 400 and 450HP
Speed: 1800 RPM
Figure 3-1 Fluid Fill Port Location