Sukup Fastir, Owner’S Instruction And Parts Manual

Page: 20 / 70

Assembly & Installation
20
Stabilizer Kit Trolley Pivot Assembly
Figure 15 - Assembly of Stabilizer Kit Pivot Assembly, Exploded View
Table 8 - Stabilizer Kit Trolley Pivot Assembly Parts List
Ref #
Description Qty Comp #
1 Bracket, Plate, Trolley – 4 ½", UHMW
Bracket, Plate, Trolley – 5 ½", UHMW
1
1
A4517
A45171
2 Trolley Bracket Cover 1 A4518
3 Wheel, Trolley, w/ Bushings 2 A6048
3A Bushing, 1/2” x 3/4” x 3/4” J0073
3B Bushing, 1/2” x 3/4” x 1/2” J0072
4 Flatwasher, 1/2” 6 J1125
5 Lockwasher, 3/8”, PLT 4 J1205
6 Screw, 1/2”-13, 2.5”, GR5, BHCS 5 J07463
7 Screw, 3/8”-16, 1.25”, PLT 4 J0616
8 Nut, Hex, 3/8”-16, PLT 4 J1020
9 Nut, Hex, Lock, 1/2” - 13 5 J1042
10 Roller, Trolley, w/ Bushings 2 A6049
10A Bushing, 1/2” x 3/4” x 1” J0074
10B Bushing, 1/2” x 3/4” x 1/2” J0072
11 Screw, 1/2”-13, 2.5”, GR5, BHCS 3 J07463
12 Bracket, Bar, Pivot Trolley 1 A45161
13 Shaft, Connect, Pivot Trolley 1 A45131-01
14 Bracket, Weldment, Pivot Trolley 1 A45122
15 If your trolley comes pre-assembled, skip to
Step 20.
16 Add a 1/2” flatwasher to each 1/2” x 2-1/2” bolt
and slide a top trolley pulley onto each, adding
second 1/2” flatwasher on outside of pulleys.
Figure 15 .
17 Insert 1/2” x 2-1/2” bolt through roller assembly.
Figure 15 .
18 Add 1/2” locknut to each bolt. Figure 15 .
19 Insert 1/2” x 2-1/2” bolt through hole on
connecting shaft and slide up through center
extended hole on weldment bracket. Add 1/2”
locknut. Figure 15 .
20 Insert 3/8” x 1-1/4” bolts through 2 holes trolley
bracket cover, bracket plate, and bracket bar,
adding 3/8” lockwashers and nuts. Figure 15 .
21 Bolt bracket bar to weldment bracket using 2 3/8”
x 1-1/4” bolts pointing down through assembly.
Add 3/8” lockwasher and nut. Figure 15 .
21.1
Note:
Bracket plate fits over crosstube.
22 Tighten all hardware. Ensure roller turns freely.