70970-UK-01
Document
INSTRUCTION MANUAL
Date
May 01 2016
Title of document
INSTRUCTION MANUAL and WARNINGS FOR USE XK 1
Revision
001
TO ENSURE YOUR USER INFORMATION IS UP TO DATE PLEASE DOWNLOAD THE LATEST VERSION OF THIS MANUAL FROM WWW.SUEX
Page 28 of 47
27 M
AINTENANCE
Lubrication of head cap O-ring case
Open the ADV, gently remove the lock O-ring (19) (see fig. 6) being careful not to scratch
the O-ring support surfaces, and clean the seating thoroughly (only by means of a clean
brush or soft cloth). Do not use any type of solvent or alcohol. Apply vaseline oil to the O-
ring and return it to its place. Do not use any other type of oil!!! Occasionally, lubricate the
lock knob screw with normal mineral grease. Never lubricate trigger or magnetic piston
movement. They would fill of sand and dirt. Do not lubricate electrical contacts!
Closing knob gasket maintenance
Whenever the closing knob (9) (see fig. 1) comes into contact with sand, rinse with running
water before rotating it. About every 50 uses, remove it, using pliers, clean the gaskets
and lubricate with vaseline oil, If you are not familiar with this operation, contact an
authorized service centre.
Aluminium body maintenance
The aluminium body was protection with a special hard anodized so that it is immune to
normal saline corrosion. When collisions or incorrect use ruin this protection, the body
material, aluminium, comes into contact with water and this could be a source of corrosion,
especially in salt water. If the protection is damaged, be careful to rinse the ADV, leaving it
in fresh water for at least 15 minutes.
NOTE: leaving the ADV exposed to the sun for long periods of time could damage
the colour creating lighter or grey areas. This situation does not compromise the
oxidation protection since it is only an aesthetic effect. Some longitudinal lines
observable on the aluminium body are perfectly normal, they depends from the
material and are not mark of defect or material stress. Please remember that surface
deterioration is considered normal wear and is not covered by the warranty.
Supplementary maintenance
Every hundred hours of use or at least every two years, we recommend you overhaul the
ADV checking hydraulic seals and electrical circuits.
SUEX S.r.l. fully overhauls your ADV with shipping throughout the world.
NOTE: using spray lubricants, it is important to air the inside of the ADV.
In this way the propelling gas go away, for the most part are
inflammable!
