Rev.06
– 03/02/2021
Pag. 30/37
Codes: 71380 - 71381
28.6. TROUBLESHOOTING
Problem
Possible cause - treatment
The SCOOTER does not run. When the trigger is
activated the propeller does not turn.
Open the SCOOTER, check that the batteries are charged and
that the connectors are inserted and undamaged, then try
again.
Although the battery pack has been charged and
the connectors are inserted the DPV does not
run.
The control system may be damaged - must be checked.*
The motor may be damaged - must be replaced.*
The battery pack may be damaged - must be replaced.
The speed regulator doesn’t work.
The control system may be damaged - must be replaced.*
The
SCOOTER’s running time is visibly
diminished.
The batteries need to be replaced.
The battery charger is broken or does not work well - must be
replaced.
When the main switch is on, the SCOOTER runs
continuously with no chance of stopping it.
The control card is damaged - must be replaced.*
The motor is noisy.
The DPV needs to be serviced.*
Vibrations are felt when the propeller rotates.
The propeller is damaged - must be replaced.
The drive system is damaged - needs to be serviced.*
The SCOOTER floods very slowly.
Replace all the O-rings and carefully check that the seating
surfaces are not damaged.
The control trigger sticks and the SCOOTER
remains running.
Shut off the SCOOTER, try to slide the starting piston, driven
by the trigger, to get out any foreign bodies, try to start again.
If the SCOOTER continues to work, the starting system must
be verified, probably it was damaged by a shock.
There are oil stains on the conic end of the case
near the propeller or it is visibly greasy.
The external propeller shaft seal is damaged and requires
maintenance. The second internal seal prevents flooding but
you should suspend SCOOTER use and replace the gaskets.
* operations to be performed in an authorized SUEX service center.
TROUBLESHOOTING PROP LOCK
Problem
Solution
Great effort is needed to turn the white knob
Th knob has been damaged, it must be replaced.
Even if the shaft pin is in the correct position in the
propeller seat, the clutch skips and the dpv does not
move forward
The traction pin has been damaged and must be
replaced. The propeller hub has been damaged and
must be replaced.
Tightening the knob turns freely and does not stop the
propeller
Too much force was used to tighten the knob and it was
damaged, it must be replaced.
Tightening the screw on the knob turns it empty
The knob has been damaged and must be replaced.
* operations to be carried out in an authorized Suex service center.
WHEN THE SAFETY CLUTCH IS TRIGGERED, STOP THE DPV IMMEDIATELY
AVOIDING THAT THE PROPELLER UNSCREWS COMPLETELY. BEFORE
RESTARTING MAKE SURE THE PROPELLER IS SCREWED BACK IN PROPERLY.
Be careful when positioning the SCOOTER vertically on the conveyor, the
propeller must not touch the ground or other object.
