Rev.06
– 03/02/2021
Pag. 13/37
Codes: 71380 - 71381
(18) with the hole (17). Turn the handwheel (9) clockwise until completely closed without over tightening using only
the force of two fingers.
11.
CORRECT USE
After the preliminary operations, proceed as follows to start the SCOOTER:
•
Always make sure that the switch (6 - Fig.1) is in the OFF position,
•
Immerse the SCOOTER in water and check that there are no foreign bodies between the propeller blades.
Otherwise, with the switch in the OFF position, remove the SCOOTER from the water and free the propeller
blades from the foreign object.
In spite the propeller is equipped with a safety clutch to reduce the risk, using the
hands or other parts of the body is a potentially danger operation.
For this reason absolutely necessary to AVOID TO INTRODUCING HANDS or other
parts of the body, INTO THE PROPELLER zone.
In case access here is needed for cleaning or undesired objects removal, use a
stick or a suitable tool.
•
Turn the switch (6-Fig.1) clockwise, completely, without forcing.
•
Grip the handle of the SCOOTER (1) or, if used, hook the carabiner to the towing harness.
•
Press the trigger (2) until the engine starts.
•
To stop the propeller, release the trigger (2).
CAUTION:
• By pressing the trigger, the propeller begins to rotate and the SCOOTER begins
to advance;
• When the trigger is pulled, the SCOOTER will not start IF the main switch is
turned to one of two speeds.
To change the speed of the SCOOTER, turn the knob (7 - Fig.1): turn clockwise to drive at moderate speed; rotate
counterclockwise to increase speed (as shown in the following figure). This change of speed can be carried out at
any time, even while diving.
When the SCOOTER is not in use, turn off the main switch (6) by turning it anticlockwise until it switches off.
12.
SCOOTER CONTROLS
12.1. SWITCH
The main switch (6 - fig.1) cuts off the battery power supply to the motor.
The use of the switch prevents accidental operation of the SCOOTER.
