TO REMOVE THE WIRE GRATE AND MAIN TOP FOR SERVICE AND
CLEANING
1.
Remove the wire grate by raising straight up. Use caution not to dislodge the
grommets in the top (one at each corner).
2.
Grasp top in the center and raise front up approximately 3”. If your unit has
sealed burners, disconnect the piezo wire at each burner.
3.
Slide top forward off the two spring clips at rear of top. Lift up top.
TO REINSTALL
1.
Reconnect piezo wires to each burner if they were removed.
2.
Align slots in rear flange of top with the tabs on the spring clips. Push top in
and press front of top down until the spring clip snaps into place.
3.
Reinstall wire grate by aligning the four (4) legs on the wire grate with the four
(4) grommets in the top. Press wire grate down into each grommet, being
careful not to dislodge the grommets.
OVEN DOOR
Do not place excessive weight on an open oven door or stand on an open oven
door as, in some cases, it could cause the range to tip over, break or damage the
door to the extent that the range would be unsafe to use, or cause serious injury
to the user.
When opening the oven door, allow steam and hot air to escape before reaching
in oven to check, add or remove food.
OVEN RACK
Your RV range features one oven rack with a choice of two or three rack positions.
The oven rack is designed with a safety lock-stop position to keep the rack from
accidently coming completely out of the oven when pulling the rack out to add or
remove food. The rack also features two tabs to keep the rack from rattling during
travel. See Figure 6.
CAUTION: Do not attempt to change the rack position when the oven is hot.
To Remove:
Be sure the rack is cool. Pull the rack straight out until it stops. This
releases the two tabs on the sides of the rack. Lift the front end of the rack up, then
pull and remove from the oven.
To Replace:
Place the oven rack in the oven on top of the rack supports. Slide the
rack to the stop position and lift upward then, as you push the rack back past the
two tabs, it will anchor the rack into place and prevent it from rattling during transit.
OVEN BOTTOM
When baking, use an adequate size cooking utensil to avoid boil overs or
spillovers.
Never place cooking utensils or aluminum foil directly on the oven bottom. This
will restrict the openings in the oven bottom, reducing the air circulation inside the
oven which will cause uneven baking, food may burn or be undercooked.
To Remove: When cool, remove the oven rack. Remove the one(1) screw and nut
that secures the oven burner assembly to the oven bottom (A Figure 7). Remove
the four (4) screws that secure oven bottom to the oven sides and back (B Figure
7). Hold oven bottom and slide it out of the oven.
To Replace: Position oven bottom rear flange to align with the two holes in back of
the oven. Secure with (2) screws. Secure oven bottom to oven sides with the two
(2) screws (see B Figure 7).
Secure oven burner assembly to oven bottom with screw and nut.
PARTS AND SERVICE
Contact a conveniently located recommended Suburban Service Center.
Describe to them the nature of your problem, make an appointment, if necessary,
and provide for delivery of your RV with the appliance installed.
To obtain information on locating a local service agency, contact:
AIRXCEL, Inc., Suburban Division
Customer Service Department
676 Broadway Street
Dayton, TN 37321
(423) 775-2131 Ext. 7101
www.rvcomfort.com
4
