35
E
N
glish
Dive planner
2 Planning a decompression dive
1. Activate the dive planner for a no-stop dive ->34.
2. Wait until the desired depth appears, then switch into decompression
planning by bridging contacts B and E. XP AIR shows the bottom
time (no-stop time + 1 minute) and the appropriate decompression
information or level stop data respectively.
3. "Add" asks that you set the bottom time. This is done with contacts
B and +, B and – respectively. As soon as the contacts are no longer
bridged, XP AIR calculates the decompression information or level stop
data respectively for this set bottom time.
If you wish to plan a decompression dive at another depth, switch from
decompression planning to no-stop planning by means of B and E. XP AIR
again shows the scrolling no-stop times. Now you can switch between no-stop
planning and decompression planning at will with contacts B and E.
If the calculated decompression information and the total ascent time exceed 99 minutes, or the CNS
O
2
% value exceeds 199%, the said values will start flashing on the display or "– –" values appear and
the decompression calculation is suspended until the bottom time has been reduced accordingly. CNS
O
2
% values higher than 199% will be displayed as 199 %.
3 Leaving the dive planner
With the contacts B and E (1-2 sec) you can exit the Dive Planner. This also occurs after three minutes
without operation.
NO STOP
%
+
–
Bottom Time
CNS O
2
%
DECO STOP
%