Black plate (209,1)
一
般
Model "A2440GE-A" EDITED: 2007/ 6/ 15
ture correctly. To avoid damaging the
sensors, observe the following precau-
tions:
–
Do not subject the sensors to impact.
–
Keep water away from the sensors.
–
Do not cover the sensors.
The sensors are located as follows:
–
Solar sensor: beside windshield
defroster grille
–
Interior air temperature sensor: near
the steering column
–
Outside temperature sensor: behind
front grille
Operating tips for heater and
air conditioner
&
Cleaning ventilator grille
1)
LHD vehicles
2)
RHD vehicles
Always keep the front ventilator inlet grille
free of snow, leaves, or other obstructions
to ensure efficient heating and defrosting.
Since the condenser is located in front of
the radiator, this area should be kept clean
because cooling performance is impaired
by any accumulation of insects and leaves
on the condenser.
&
Efficient cooling after parking
in direct sunlight
After parking in direct sunlight, drive with
the windows open for a few minutes to
allow outside air to circulate into the
heated interior. This results in quicker
cooling by the air conditioner. Keep the
windows closed during the operation of
the air conditioner for maximum cooling
efficiency.
&
Lubrication oil circulation in
refrigerant circuit
Operate the air conditioner compressor at
a low engine speed (at idle or low driving
speeds) a few minutes each month during
the off-season to circulate its oil.
Climate control
4-11
–
CONTINUED
–
4