Subaru Legacy 2021, Owner'S Manual

Page: 44 / 592

(40,1)
北米Model "A2600BE-B" EDITED: 2020/ 10/ 1
Each head restraint should be adjusted so
that the center of the head restraint is
closest to the top of the occupant’s ears.
NOTE
It is not possible to remove or install the
head restraint without reclining the
front seatback. Reclining the front seat-
back and then remove or install the
head restraint.
! Head restraint angle adjustment
The angle of the head restraint can be
adjusted in several steps. While maintain-
ing a suitable driving posture, adjust the
head restraint to a position where the back
of your head is as close to the head
restraint as possible.
To tilt:
Tilt the head restraint by hand to the
preferred position. A click will be audible
when the head restraint is locked.
To return:
Tilt the head restraint once as far forward
as it can go. The head restraint will
automatically return to the fully upright
position. Then, adjust the head restraint
again to the preferred angle.
1-2. Seat Heater (If Equipped)
The seat heater operates when the ignition
switch is in the “ON” position.
CAUTION
. Do not put hard or heavy objects
or ones with protrusions on the
seat, and do not stab the seat
with sharp objects, such as pins
or needles.
. People with delicate skin may
suffer slight burns even at low
temperatures if they use the seat
heater for a long period of time.
When using the heater, always be
sure to warn the persons con-
cerned.
. Do not put anything on the seat
which insulates against heat,
such as a blanket, cushion, or
similar items. This may cause the
seat heater to overheat.
. When the seat is warmed enough
or before you leave the vehicle,
be sure to turn off the seat heater.
NOTE
. Use of the seat heater for a long
period of time while the engine is not
Seat Heater
38