Integrated
Integrated
(700-
(700-
3
3
T
T
ALL)
ALL)
Series
Series
Component Access/Removal
7-11
#3758412 - Revision B - December, 2006
Drawer Closer Assembly Removal (All Models)
The drawer closer assemblies are located on the right
side wall, towards the front of the two drawer areas.
Screws secure each drawer closer to the wall.
To access and remove a drawer closer assembly, first
remove the appropriate drawer. Then, extract the
screws that secure the drawer closer to the wall. (See
Figure 7-20)
Drawer Slide Assembly Removal (All Models)
The four drawer slide assemblies are attached to the
side walls with Allen-head screws passing through the
drawer slide bracket into blind threaded inserts.
To access and remove a drawer slide assembly, first
remove the drawer. Then, extract the drawer slide
mounting screws with a 5/32" Allen-head wrench, and
pull the drawer slide assembly away from the wall.
(See Figure 7-21)
NOTE:
The pins at front end of the drawer slides are
replaceable. Screw pins counterclockwise to remove
them. (See Figure 7-22)
Icemaker Assembly Removal
(All Models with Icemakers)
The icemaker is attached to a support plate with screws
that pass up through the plate into the bottom of the
icemaker. The ice level arm is also attached to the sup-
port plate using two P-clamps and two screws. The P-
clamps fit around rods at the back of the ice level arm.
Screws passing through the P-clamps secure them to
the support plate at the rear. At the front, a connecting
rod is used to attach the ice level arm to the icemaker
shut-off arm. This whole assembly is attached to the
evaporator cover with three mounting screws, two at
the top and one at the bottom.
To access and remove the icemaker assembly, first
remove the bottom drawer, then (See Figure 7-23):
1. Extract mounting screw at bottom and two top
mounting screws.
2. Lower the icemaker assembly down and disconnect
wire harness from back left of icemaker.
3.
The icemaker can now be removed from the sup-
port plate by sliding the connecting rod off of the
shut-off arm, then extracting the screws from bot-
tom of icemaker.
Drawer Closer Assy
Figure 7-20. Drawer Closer Assembly Removal
Figure 7-21. Drawer Slide Assembly Removal
Drawer Slide Assy
Figure 7-22. Pin Replacement
Pin
Figure 7-23. Icemaker Assy
Icemaker
Mounting Screw
Shut-off Arm
Connecting Rod
Summary of Contents for 700TC-3
Page 2: ......
