Integrated
Integrated
(700-
(700-
3
3
T
T
ALL)
ALL)
Series
Series
Component Access/Removal
7-5
#3758412 - Revision B - December, 2006
Figure 7-6. Door Assembly Removal
Hinge Cover
Remove two inner-most
screws at top and bottom
hinge with door open.
Remove two outer-most
screws at bottom hinge
first then at top, with door
closed.
Door
Assembly
Hinge Arm
1
2
Door Assembly Removal (All Models)
The door assembly is held in place with Allen-head
screws that pass down through the arm of the top hinge
assembly and up through the arm of the bottom hinge
assembly, then into the door. These mounting screws
are concealed by a hinge cover on each hinge arm.
The hinge covers are held in place by tabs that fit into
notches in the hinge arms.
NOTE:
Removing the top drawer first will make this
task easier.
To remove a door assembly (See Figure 7-6):
1. Open door and removing both hinge covers.
2. With Allen-head wrench, extract the two inner-most
door mounting screws from top and bottom hinge
arms, leaving the two outer-most screws in place.
3. Close door and extract the outer-most door mount-
ing screws from bottom hinge arm.
4. Extract the two outer-most door mounting screws
from top hinge arm.
5. Lift door from unit.
Upper and Lower Hinge Assembly Removal
(All Models)
The hinge assemblies are attached to hinge mounting
brackets with Allen-head bolts.
To remove a hinge assembly, you will need to remove
the door assembly first. Then, extract the Allen-head
bolts from the appropriate hinge mounting bracket and
pull the hinge assembly from the unit. (See Figure 7-7)
Figure 7-7. Hinge Assembly Removal
Hinge Arm
Bolt
Bolt
Summary of Contents for 700TC-3
Page 2: ......
