Page 13
Installation Information
Wine Storage
Wine Storage
(400-
(400-
2
2
)
)
Series
Series
2-8
#3758410 - Revision C - May, 2014
Figure 2-20. Poly Tape Removal
Figure 2-21. Stainless Steel Door Panel Removal
Poly Tape
Door Gasket
Door Frame
Handle
Screws
SS Handle
(
Door Hinges &
Screws - not shown)
SS Panel
Poly
Tape
Door Assy
METAL DOOR PANELS MAY HAVE SHARP EDGES.
PROTECTIVE GLOVES SHOULD BE WORN WHEN
HANDLING PANELS.
DOOR PANELS MAY BE HEAVY OR UNSTABLE. IF
THEY WERE TO FALL, THEY COULD CAUSE SERI-
OUS PERSONAL INJURY.
Door Panel Removal and Installation (All Models)
Figure 2-19. Door Closer Removal
Door Closer
Hinge Pin
Classic, carBon and Platinum Stainless Steel Door
Panel Removal and Installation (424-2)
To remove a 424-2 SS door panel, the door must first
be removed from the unit.
To Remove the Door:
1.
Remove mounting screws securing door closer to
the unit base (See Figure 2-19)
2.
Slide door closer down off of bottom door hinge pin
NOTE:
It may be necessary to lean unit back
slightly to create enough clearance between hinge
pin and floor.
3.
Open door and extract screws from top door hinge.
4.
Lean door away from unit slightly and lift door out of
bottom cabinet hinge.
To Remove a Stainless Steel Panel:
1.
Lay door down and remove bottom door hinge and
switch depressor. (If lock and/or screws are pres-
ent on bottom handle side, remove them also.)
2.
Remove Poly-tape under gasket on handle side
which covers handle mounting screw holes (See
Figure 2-20).
NOTE:
Do not discard tape. It must be reapplied
when panel is reinstalled.
3.
Extract handle mounting screws and pull handle
from front of door (See Figure 2-21).
4.
Lift stainless steel panel from door.
NOTE:
To install stainless steel panel, reverse steps
above.
