Stuv 16-cube Series, Installation Manual

Page: 41 / 48

41
7
MAINTENANCE STÛV 16-CUBE & 16-H
Step 11
Only remove the upper pivot
if it
is damaged.
If needed, use a 10 mm hex
socket to unscrew the door.
Step 12
The spring is supported in two
places. The straight pin is behind a screw
(use a 3 mm Allen key) while the spring's
cylinder is wrapped around a screw (5
mm) and a pivot (10 mm).
Step 13
Remove these three pieces of
hardware to change the spring.
Step 14
Unscrew the nuts to remove the
gasket clamps and glass retaining clips.
Step 15
The glass pane is the last
component to disassemble. Check the
seals and change them or the pane if
needed.
The glass must be 4 mm-thick ceramic
and able to withstand high temperatures.
cylinder
right pin
13
12 11
16 15 14
10
mm
3
mm
5
mm
10
mm
7
mm
Stûv symbol
at the bottom of the glass
pane with the writing in the
right direction.
MODEL GLASS PANE
16-58
439 mm x 466 mm
16-68
439 mm x 566 mm
16-78
439 mm x 666 mm
.2 REPLACING COMPONENTS
Step 16
Follow the steps in reverse to re-
assemble the door and reattach it to
the appliance.
• Replace the glass pane and gasket.
• Screw the seal clamps back on with the nuts.
• Re-place the closing axis and screw it back on.
• Reinsert the door gasket.
• Put the door back on its hinges.
• Screw the spring on and re-engage it.
• Close and lock the door.