Stulz FLAIR series, Installation, Operation And Maintanance Manual

Page: 13 / 48

FLAiR Series Installation, Operation & Maintenance Manual
(©Aug, 2007)
Air Technology Systems, Inc.
2-2
CAUTION
When moving the unit, it must be kept level and
in the vertical position to prevent damage to the
unit.
2.4 Mounting/Placement
FLAiR precision A/C systems are designed to be
located in the space to be conditioned and are de-
signed to supply air to only one room. The unit(s) may
be placed directly on top of the floor in a corner or
side-by-side between cabinetry. If floor space is
limited, the unit may be mounted directly to a wall,
(see Figure 4). It is recommended to position the unit
to obtain optimum air circulation.
2.4.1 Indoor Equipment
The FLAiR precision A/C system uses a frame and
panel construction for unit rigidity and full service
accessibility while the unit is mounted in place.
Ensure the mounting surface is able to support the
weight of the equipment. Before mounting the unit,
refer to the weight table provided on the installation
drawing.
NOTE
Equipment must be level to operate properly.
2.4.2 Outdoor Equipment
Install the remote condenser/condensing unit in a
secure location where the unit cannot be tampered
with and the service disconnect switch cannot be
inadvertently turned off. Locate the remote condenser/
condensing unit where the fan is not likely to draw dirt
and debris into the coil fins. There should be at least
24 inches of clearance around the condenser to
ensure adequate airflow to the coil. Secure the
condenser/condensing unit to prevent the system from
moving during operation. It is recommended that the
remote condenser/condensing unit be installed with
vibration mounts to reduce vibration transmitted to the
mounting surface.
Figure 4- Typical Installation
Wall Mounted Floor Mounted
RETURN AIR
INLET
SUPPLY AIR
OUTLET
RETURN AIR
INLET
SUPPLY AIR
OUTLET