Studer D424, Operating And Service Instructions

Page: 187 / 189

D424 MO Recorder
Date printed: 06.03.02 SW V 1.6/V 2.6
Appendix E9/7
9.2 Drive Installation Instructions
9.2.1 MO Drive Kit 2.6 GB (ISO)
9.2.1.1 Settings
The following settings at the functional switch have to be checked at the
rear of the drive:
Jumper 3 inserted (SCSI address 1; refer to section 5.2)
Jumper 7 inserted (force verify after write)
Jumper 11 inserted (termination on)
9.2.1.2 Installation
1. Disconnect the unit from the mains supply and remove the cover.
2. Disconnect the power cable and the SCSI ribbon cable on the rear side of
the currently installed drive.
3. Remove the old drive by removing the fixing screws (2 at each side).
On units with serial number below “ 1001” that were shipped with the
2.2 GB Pioneer drive, the two drive mounting brackets have to be re-
placed. The new brackets are part of the upgrade kit and allow the instal-
lation of a wide variety of drives.
4. The new ISO drive is mounted from the front of the D424, by sliding it
through the front panel opening and attaching it with the 4 corresponding
screws at the brackets.
5. Reconnect both power supply and SCSI ribbon cables to the ISO drive and
reinstall the cover.
9.2.1.3 Accessories
The 2.6 GB ISO drive is capable of recording to and playback from the
following ISO compatible disks (all disks available on request):
1.2 GB 512 bytes/sector
1.3 GB 1024 bytes/sector
2.3 GB 512 bytes/sector
2.6 GB 1024 bytes/sector
1 12 1
2
49
50
4 1
Functional Switch
with default
jumper setting
SCSI Connector Supply Connector