29
Programming and installation manual Careline Anna / Careline GSM
Doc. no. 32-022-03-01 EN v6
9
Description of menu selection in the hand terminal
Main menu
Edit alarm code
Means that the carephone sends the same alarm code to all programmed alarm receiver. To send different
alarm codes to different alarm receivers, go instead to the menu
>Alarm codes<.
The alarm code can
contain a maximum of 16 digits.
Speaker volume
Controls the volume of the speaker in steps from 0 to 7, where 0 is the lowest value and 7 is highest. Here
you can control the call volume and the volume of the audio signals of the carephone, for example, before
an alarm call.
Quit
At quit, the user is asked do you want to send changes to the carephone. Answer Yes, and all the
programmed values are transferred from the hand terminal to the carephone. Answer No, and the
programming is terminated without transferring any values. Note that values not saved in the preset area
are lost if you choose to quit.
Load from preset
Means you can download the preset values, which is then saved in the memory area. Every time HT is
started, the preset values from area 1 are downloaded automatically.
Programming
Specify the code 1812 to go to the next step in the menu.
Programming
Load from Phone
All values stored in the carephone are read. The reading takes a few seconds.
Load standard values
Erases the memory in the hand terminal and loads the factory preset values. There is then no information
relating to phone numbers, alarm codes and alarm transmitters.
Save to preset
This means that programming changes that have been executed are stored in the hand terminal memory.
You are requested to enter a code, which is 1789. All program changes which are not specific for an
individual carephone should be stored with this command. There are seven memory areas for each
carephone model. The values stored in area 1 appear every time you connect the carephone.
Load from preset
Means you can download the preset values saved in any of the memory areas. Every time HT is started it
automatically downloads the preset values from area 1. (The same menu choice is in the main menu.)
Program
Means that you enter the menu where all the parameters you want to program or change are
representated.
>Phone numbers< >Addresses< >Transmitters< >Alarm types< >Location codes< >Alarm codes<
>Protocol< >Sequences< >Attempts< >Connection type< >Outgoing call< >Incoming call< >Timers<
>Extended<>I/O< >Options< >GSM functions< >Advanced< >Phone version< >Menu version<
