Programming and installation manual Careline Anna / Careline GSM
Doc. no. 32-022-03-01 EN v6
Choose the model you want to program by pressing
and
and then press
Yes
.
Go to the next step: programming of the telephone number
4.2.2
Programming of the telephone number of the alarm receiver
If an alarm is to ring via the analogue telephone network or via GSM, the telephone number must be
entered. In that case, continue with the programming as follows:
Choose
Programming
, press
Yes
Enter code
1812
Choose
Programming
, and press
Yes
Choose
Phone numbers
, press
Yes
. Choose
Phoneno. A
, press
Yes
Enter the phone number from the alarm number table in Appendix A. Write the numbers in sequence
without a hyphen. To delete numbers if you accidentally press wrong, press
.
If you have to enter a 0 to access an outside line, enter
0
and then
T
before entering the usual number, for
example, "
0T040123456
". T stands for Tone (Connection Tone).
Finish by pressing
Yes
.
Press
for the next number and repeat the procedure above to add the telephone numbers B, C etc.
Press
No
to exit the menu "Phone numbers".
Terminal VX.YSE
connects
Careline GSM
MAIN MENU VX.YSE
>Edit alarm code <
Speaker vol.
Quit
Edit alarm code
Speaker vol.
Quit
>
Programming
<
<
Enter password:
- - - -
PROGRAMMING
>
Program
<
Load from phone
Load std.values
PROGRAM
>P
hone numbers
<
Addresses
Transmitters
PHONE NUMBERS
>
Phoneno. A
<
Phoneno. B
Phoneno. C
Value in HT:
<not programmed>
New Value:
XXX…
Value in HT:
<not programmed>
New value:
0T040123456
