Programming and installation manual Careline Anna / Careline GSM
Doc. no. 32-022-03-01 EN v6
5.2.2
Programming the alarm transmitter via the buttons
To program an alarm transmitter for Careline Anna/GSM without using the hand terminal, do as follows.
Press the green button and hold.
Also press the red and grey buttons and hold them down until an ascending beep is heard. You can then
release all buttons.
Now you are in the carephone programming mode, as indicated by the light switching between the LEDs.
Hold down the red, and wait for the number of beeps that corresponds to the transmitter position you want
to program. (See table in section 5.1.3.)
When the correct number of beeps is heard, release the red button and activate the transmitter you want to
program.
A received signal is heard from Careline Anna/GSM when the radio code has been received.
To program more transmitters, press the red button again and wait for the beep. Otherwise, press the green
button to exit programming mode.
Then try to send an alarm from the programmed accessory.
Note! You can also program as per the previous carephones, by turning off the carephone and holding the red
button when you restart it and then release the red button and activate the transmitter in line with the correct
number of beeps.
5.2.3
Deprogramming the alarm transmitter via the buttons
Press the green button and hold.
Also press the red and grey buttons and hold them down until an ascending beep is heard. You can then
release all buttons.
Now you are in the carephone programming mode, as indicated by the light switching between the LEDs.
Hold down the red, and wait for the number of beeps that corresponds to the transmitter position you want
to program. (See table in section 5.1.3.)
When the correct number of beeps is heard, release the red button and briefly press the grey button.
A received signal is heard and the alarm transmitter is then deprogrammed.
To deprogram more transmitters, press the red button again and wait for the beep. Otherwise, press the
green button to exit programming mode.
Note! You can also deprogram as per the previous carephones, by turning off the carephone and holding the red
button when you restart it and then release the red button and press the grey button in line with the correct
number of beeps.
5.2.4
Change the speaker volume
You can easily change the speaker volume, even if you do not have a hand terminal available.
Press the green button and hold.
Also press the red and grey buttons and hold them down until an ascending beep is heard. You can then
release all buttons.
Now you are in the carephone programming mode, as indicated by the light switching between the LEDs.
Press the grey button down until you hear a beep. Then release the button.
The carephone now gives off a number of beeps corresponding to the speaker volume that is currently
selected. The volume is adjustable between 1 and 8 beeps.
o
To increase the volume: press the red button
o
To decrease the volume: press the grey button
Every time you press the grey or red button, the carephone speaker volume is indicated by both the
number of beeps and the adjusted volume level.
When you are satisfied with the level, press the green button to save the settings.
Then press the green button again to exit the programming mode.
