Programming and installation manual Careline Anna / Careline GSM
Doc. no. 32-022-03-01 EN v6
Image 6. Data flow between the memory areas in the handterminal and the carephone.
4.2
Creating and Saving Programming in the Hand Terminal
Follow these instructions step-by-step to program the default values that you want to program the carephone
with, and save these in the preset area. All the values that are common for all carephones should be here. This
saves you entering them each time you program a carephone, you can simply enter the values specific to this
carephone (usually only the alarm code) and then transfer it with the default values you previously saved in the
hand terminal to the carephone. Use the completed tables in appendix A to facilitate programming.
Note! This section gives you a good basic programming, but the carephone offers many more possibilities than
these! Please read section 8 in which almost all the features found in Careline Anna/GSM are described.
4.2.1
Connect the Hand Terminal
Connect the mains adapter to the hand terminal's smallest outlet (see image 7 below) and to a standard
electrical socket.
Image 7. Connect the Hand terminal's smallest outlet, as per the image above.
The display of the hand terminal shows the following:
Press
on the hand terminal. The display will show:
Connect to the
carephone
or press
to stand alone
Arbets-
area
Reset Area
Preset Area
Load std. values
Save to preset
menu selection
Upload on
start up
Carephone
Load from TT
Send changes
Working
Area
DEVICE TYPE
>Careline GSM <
Careline Anna
Reflex Plus II
