Stryker Prime TC, Maintenance Manual

Page: 25 / 64

D
E
F
G
H
C
A
B
Torque item F
to 70 ± 10 in-lb
F Fiig gu urre e 1 13 3 –– B Brra akke e ffiin ng ge err a asssse em mb bllyy rre ep plla acce em me en ntt
4. Using snap ring pliers, remove the retaining ring (D) that secures the rear wheel shaft assembly (E) on the chair frame.
Save the retaining ring.
N No otte e -- Do not open the retaining ring larger than necessary for removal.
5. Remove the rear wheel shaft assembly (E).
6. Using a 5/32” hex wrench and a 3/16” hex wrench, remove the screws (F) and brake finger spacer nuts (G) that secure
the brake finger assembly (H). When reinstalling the screws (F), use a 3/8” drive torque wrench to torque the screws to
70 ± 10 in-lb.
7. Remove and discard the brake finger assembly (H).
8. Reverse steps 2-7 to install the supplied brake finger assembly.
9. Replace the brake/go pedal assembly (see Pedal replacement (page 18)).
N No otte e -- When reinstalling the brake cam assembly (P), make sure that the tab faces the front of the chair.
10. Verify proper operation before you return the product to service.
1460-009-002 Rev B.0 21 EN