7. Verify proper operation before you return the product to service.
PPoowweerr ccoorrdd rreeppllaacceem
meenntt
TToooollss rreeqquuiirreedd::
• Zipper pull tool or equivalent
• 5/16” Nut driver
• 1” Combination wrench
• Diagonal pliers
PPrroocceedduurree::
1. See
2. Using diagonal pliers, cut the cable tie (BG) (Figure 15) and discard.
NNoottee
• Pay attention to the orientation of the cable tie for installation of the new power cord.
• From the inside of the foot box, install the supplied cable tie through the top hole with the cable tie lock to face up.
Feed the cable tie around the new power cord and through the bottom hole in the foot box to secure the power cord
to the foot box.
• During installation, before you cut the end off of the cable tie, use the diagonal pliers to pry the slack out of the cable
tie (one to two clicks).
F
FFiigguurree 1155 –– PPoowweerr ccoorrdd
3. Using a 5/16” Nut driver, remove the two nuts (H) and four star washers (D) that secure the power cable ground
connector (Figure 15). Save the nuts and star washers.
NNoottee -- During reinstall, torque (H) to 22 ± 4 in-lb
4. Using a 1” combination wrench, remove the nut (E) that secures the power cord strain relief to the foot box.
2972-009-002 Rev AA.0
37
EN
Summary of Contents for Isolibrium 2972
