Strontech IMB-H114, Instructions Manual

Page: 13 / 38

24 25
SATA1~4: Serial ATA 6.0Gb/s connector
This connector is used to support the Serial ATA devices for the highest data transfer
rates (6.0 Gb/s), simpler disk drive cabling and easier PC assembly.
1
Ground
2
TX+
3
TX-
4
Ground
5
RX-
6
RX+
7
Ground
8
No pin
Pin Signal Name Pin Signal Name
TPM: Trusted Platform Module header
Trusted platform module (TPM) is a published specification detailing a
microcontrollerthat can store secured information, and implementations of that
specification.
1
TPM_CLK
11
LAD0
2
GND
12
GND
3
LFRAME#
13
RESERVE0
4
No pin
14
RESERVE1
5
LREST#
15
VCC3_DUAL
6
SMBDATA
16
SERIRQ
7
LAD3
17
GND
8
LAD2
18
GND
9
VCC3
19
LPCPD#
10
LAD1
20
SMBCLK
Pin Signal Name Pin Signal Name
COM2~10 : Onboard serial port headers
Connect a serial port extension bracket to this header to add a second serial port to
your system.
1 Data Carrier Detect 6 Data Set Ready
2 Serial Input 7 Request to Send
3 Serial Output 8 Clear to Send
4 Data Terminal Ready 9 Ring Indicator
5 Ground 10 No pin
Pin Signal Name Pin Signal Name
Please make sure that the USB cable has the same pin assignment as
indicated above. A different pin assignment may cause damage or system
hang-up.
F_USB1: Front Panel USB 2.0 header
The onboard F_USB1~3 header delegate for card reader, it supports additonal six
USB 2.0 ports.
1
Power +5V 6 USB Port B (+)
2
Power +5V 7 Ground
3
USB Port A (-) 8 Ground
4
USB Port B (-) 9 No pin
5
USB Port A (+) 10 Not Connected
Pin Signal Name Pin Signal Name
DIO: 4 bit GPIO header
F_USB2: Front Panel USB 2.0 header
The onboard F_USB header delegate for card reader, it supports additonal one USB
2.0 port.
1
USBPWR Front Panel USB Power
2
l a n g i S e v it a g e N t r o P B S U - A T A D
3
DATA+ USB Port Positive Signal
4
d n u o r G D N G
5
No pin No pin
Pin Signal Name Function
1 GPIO3 6 GPIO5
2 GPIO7 7 GPIO0
3 GPIO2 8 GPIO4
4 GPIO6 9 +5VSB
5 GPIO1 10 GND
Pin Signal Name Pin Signal Name