26
&OHMJTI
6.8.1. GOTO ANGLE
Turns the motor to the entered Angle. Enter the angle with
digits and use BLUE button to change direction. Press Ok
to let it turn. Some Diseqc 1.2 positioners do not support
go to angle command. If your positioner does not support
this function you can enter 000 for the angle in order to turn
the positioner to the reference zero position
6.8.2. DRIVE MOTOR
Drives the motor East or West and rotates the antenna on
the polar axis. East or West will continuously blink on the
screen to indicate the direction the motor is moving. To
drive the motor toward a specific direction,
“ ’’
or
“ ’’
button should be kept pressed.
6.8.3. MOTOR SPEED
Adjusts the speed of the motor. There are two modes,
Fast and Slow. Fast mode is useful for driving the motor
over large angles or coarse adjustment. Slow mode
comes handy when fine-tuning is needed.
6.8.4. SET EAST LIMIT
Stores the current location of the positioner as the east
limit.
6.8.5. SET WEST LIMIT
Stores the current location of the positioner as the west
limit.
6.8.6. ENABLE / DISABLE LIMITS
Enabling the (software) limits will cause the motor not to
drive after east or west limit is reached. When the software
limits are disabled, the positioner motor will drive over the
full (mechanically-defined) arc of its movement.
6.8.7. STORE SATELLITE POSITION
When the desired signal quality is reached, the user can
store the current location of the positioner. This functionality
enables the Positioner Motor Unit to drive back at any later
time to the antenna shaft position stored by the user.
6.8.8. POSITIONER RESET
Restores build in Satellite Table for the positioner Motor
Unit.
6.8.9. RECALCULATE SATELITE
POSITIONS
The positioner motor unit recalculates satellite positions of
the other satellites.
All manuals and user guides at all-guides.com
all-guides.com
